How to Tackle
a Stain or Spill: Accidents do happen. These tips will help you safely
spot clean fabrics.
Things
You Should Do:
Know your fabric.
Spills and stains are never planned! If you understand the special
characteristics of your fabric, you'll be able to respond appropriately.
Always blot
from the outside of a spot to the center of the spot. This will help
control the spread of a spill.
Test your fabric
in a hidden area to make sure the color doesn't come off with the
stain or ringing occurs.
If this spot
is liquid, use an absorbent cloth or white paper towel and gently
blot up the excess.
If the spot
is solid material, remove the excess by lifting off with a dull table
knife or spoon.
Things
You Should Not Do:
Never rub, scrub,
or brush a spill. Elbow grease doesn't work on stains and spills.
Never use strong
chemicals like bleach, solvents, or acids unless recommended by a
specialist.
Never use sudsy
detergents. They will leave a soapy residue that attracts soil.
Don't use tap
water. Use distilled water or plain seltzer waster. Minerals in common
tap water can cause rings. Even on treated fabrics.
Avoid commercially
available furniture and rug cleaners. Most foster rapid resoiling.
Expert
Advice on Some Common Problems!
Beverages: alcoholic, colas, fruits, juices, medicines, mildew,
mustard, tea, and wine
Step
#1: If pre-testing indicates water is safe, slightly moisten
the spot with distilled water or club soda using a clean white towel.
Blot with a dry towel. Repeat. Be careful not to over wet.
Step
#2: If stain remains after process is repeated 3 or 4 times,
test an inconspicuous area with household strength (3%) hydrogen peroxide.
Allow this to dry thoroughly and check closely for color loss. If
OK, apply solution to spot with a cotton swab. Allow to dry.
Berries, Blood,
Ketchup, Chili Sauce, Chocolate, Coffee with Cream, Dressings, Egg,
Mayonnaise, Meat, Milk, Sauces, Soup, Tomato Sauce:
Follow Step
1 for beverages. If stain remains, test hidden area with a laundry
pre-spotter containing enzyme. Dry. Then sponge tested area with water
and blot with dry towel. Dry again. If area tested is OK, apply pre-spotter
with a cotton swab and blot with dry towel. Take care not to soak
fabric. If enzyme does not remove all traces of stain, follow Step
#2 under beverages. If grease remains, apply spotter such as 1,1,1
trichloroethane and follow instructions under grease.
Nail
Polish: Test this procedure first with the same polish in
a hidden area. Apply oil free mail polish remover or acetone with
a cotton swab and absorb it gently with a white paper towel. Go slowly!
Grease
(Butter, Margarine, Etc.): Lift off excess with dull knife.
Apply a few drops of dry-cleaning solvent such as 1,1,1 trichloroethane
(available under brand name spotting products) with a cotton swab
and immediately sprinkle with plain talcum. Vacuum and repeat until
no traces of grease remain.
Cosmetics:
Exercise extra care. Dyes and solvents can cause serious damage to
any fabric. Be very careful not to spread the stain. After testing,
apply dry-cleaning spotter with cotton swab and blot with towel. Repeat.
If stain persists, call a professional.
Ink:
Some water-based inks can be removed by sponging with alcohol. Always
test with the same pen on inconspicuous area. Ball point can be easily
set. Acetone, used very sparingly, often removes most traces. Follow
procedures for grease, using acetone. Caution: acetone can dissolve
some synthetics. Always test.
Shoe
Polish: Sponge with distilled water or club soda. If stain
remains, sponge with alcohol. If color remains, follow Step #2 under
beverages. For wax-based shoe polish, follow procedure for grease
spots.
Urine:
Mix equal parts white vinegar & distilled water and follow #1d
under beverages.
Vomit:
Add 1 Tablespoon non-sudsy ammonia to 1 cup distilled water and follow
procedure #1 under beverages.